outdoor aluminum picnic table at BuiltRiteBleachers.com

WARNING !!!   All Commercial Picnic Tables are not Created Equal 

When comparing commercial aluminum picnic tables, be sure to check the frame design.  You will note that the frame design on our tables is a molded one peice design that curves upward and then inward toward the table top.  

This inward curve places the center of gravity closer to the middle of the table which helps to prevent it from tipping over.  Other table manufacturers use a welded leg frame design that comes straight up at a 90 degree angle 

to the seat.  In the past we too sold a similar style table, but discontinued selling it because we have found that design is prone to tipping over when people sit on one side of the table only. 

Our picnic tables can be seen in many National, State and Local Parks throughout the US and Canada. These aluminum tables are maintenance free and long lasting. Table Legs are constructed of hot dipped galvanized steel. Tabletops and seat planks have a groved finish and are the same in length. Both tabletops and seat planks are contructed with 2" X 10" anodized aluminum plank. Our standard models have 1 5/8" diameter legs and are available in 6,8,12, & 15 foot lengths. The 6 and 8 foot length models have 2 legs and the 12, and 15 foot models have 3 legs. Width of table from outside edge of leg to outside edge of leg is 66 5/8" , from outside edge of seat plank to outside edge of seat plank is 61 1/2"

• Click here for product drawing
• Click here for product specifications